Search results

This was a cable. Both sides working just fine. Thanks!

Thanks for the reply. Will double check the cables. I can turn loop 6 on without loop 5 and everything works as it should in full stereo. Just something with Loop 5.

I see what I am doing on this one. The PC Messages int he middle of the screen should be set correctly instead of using the PC on Preset Actions. Sorry Newbie post.

See image. I have this same Preset Actions setup for each Preset. It loads the patch 100 on the BigSky MX fine on 1st preset. When I go to the next preset with the same preset actions, it is setting it to a different patch on the MX. The next preset it goes back to correct number on the MX.

I have been searching through the forum, can't get his fixed. I am running the H90 in dual mode. I have the "A" side running out Loop 5 (Insert Cable tested) into 1/2 H90, out 1/2 H90 to Retrun Loop 5 (Insert Cable tested). After Loop 6 (Stereo), Out Stereo, into H90 3/4 out 3/4 to Reverb to...

Was wondering how you have the H90 wired? I am currently running a simple GigRig Quartermaster and have the H90 in Dual mode so I can run pre/post on effects. I have a PBC 6x coming and was going to run a stereo through the insert so I can move it around in the chain, then out stereo to 2nd...

Unplugging the power worked. Just used the USB-C from the mac to the pedal to power it. Excellent drive pedal! Great work.

Using an M1 Mac connecting via USB-C to USB-C to the Full English. The Pedal Editor will not connect. Cable connects to the MC6 Pro with no problem. Can we run the pedal editor off the USB-C port?

So I started with a clean PBC. Sent a program change to get the Midi channel set. All is working. Now I can't get the Meris to work. Running it through a disaster area Midi box.

Trying to setup the D1. I set it up as a generic device, just set the midi channel. Not getting it to react to bypass, when I change a preset it is changing, but not getting the bypass cc to change anything on the pedal. Also trying out a Disaster Area Midi box connected after the D1...

I have been working on a board using GigRig power. Using Timelord on each device (3 Strymon, PBC and Quartz). Use two distributors, to break out to 3 isolators. Nothing run direct off the Distributors. All drive pedals are running off isolators. When I route my first drive pedal, the power...